Skip the manual navigation

Choose your email delivery provider and send a test email

Send customer emails through Lulu's platform sender by default, or connect your own Resend or Mailjet account to send from your own domain.

8 min read · Updated October 2, 2026 · Screenshots use demonstration accounts

On this page
  1. 1. Open Email delivery
  2. 2. Choose Send through
  3. 3. Set your sender
  4. 4. Add your API key(s)
  5. 5. Save
  6. 6. Send a test email
  7. 7. Know what doesn't change
  8. Completion checklist
  9. Troubleshooting
Before you start

A Resend or Mailjet account and a verified sending domain, if you choose your own provider.

On a phone? Open the admin menu to find the same section. Screenshots below show the desktop view; tap “Open full size” for a closer look.
STEP 1

Open Email delivery

Go to Settings → Notifications. Email delivery is the first card.

STEP 2

Choose Send through

Keep Platform default to send through Lulu's shared sender, or choose Resend or Mailjet to send from your own domain.

STEP 3

Set your sender

If you chose your own provider, enter a Sender such as "Shop name <[email protected]>". The address must be on a domain you have verified with that provider.

STEP 4

Add your API key(s)

For Resend, paste your Resend API key. For Mailjet, paste both the Mailjet API key and the Mailjet secret key. Keys are stored encrypted and never shown again; leave a key field blank on a later save to keep the saved key.

STEP 5

Save

Click Save. You can't save Resend or Mailjet without a sender and the required key(s).

STEP 6

Send a test email

Click Send test email. A test message goes to your own staff email address through the saved settings, and the card shows either who it was sent to and how, or the reason the provider refused it.

STEP 7

Know what doesn't change

Replies to customer emails still go to your store email, whichever provider sends the message.

CHECK YOUR WORK

You’re ready when…

    IF SOMETHING DOESN’T LOOK RIGHT

    Troubleshooting

    The test was sent through the platform provider, not my own.

    The test uses your saved settings. Choose your provider, click Save, then click Send test email again.

    Send test email says the provider refused it.

    Check that the API key (and, for Mailjet, the secret key) is correct and that the sender's domain is verified with that provider. An unverified domain is the most common cause.

    I switched back to Platform default. Do I need to delete my API keys?

    No. Platform default simply stops using the saved keys. If you switch back to your own provider later, the saved keys are used again unless you enter new ones.

    In this section: Notifications & email delivery

    Still need help?

    Tell us your store address and what you’re trying to do. Leave out passwords and payment details.

    Contact support